PROCEDURE A
- Start with driver’s door open and key removed from the ignition switch.
- Within 5 seconds, insert and remove the key from the ignition two times.
- Within 40 seconds, close and then open the driver’s door two times.
- Insert and remove the key from the ignition one time.
- Within 40 seconds, close and then open the driver’s door two times.
- Insert the key into the ignition and close the driver’s door.
- Choose one of the following modes:
- Switch the ignition from ON to OFF one time to program a remote while retaining the original codes.
- Switch the ignition from ON to OFF twice to program a remote while erasing the original codes.
- Switch the ignition from ON to OFF three times to check how many remote transmitters are currently registered.
8. Remove the key from the ignition.
9. System should now lock and unlock the vehicle. Once, twice, or five times depending on which mode has been selected. One to four times, slowly, to indicate the number of remotes registered to the vehicle.
10. Within 40 seconds, press and hold remote transmitter’s LOCK and UNLOCK buttons simultaneously for 1.5 seconds and release.
11. Within 3 seconds, press remote transmitter LOCK button for 1 second.
System should now LOCK and UNLOCK vehicle. Once to confirm programming was successful, twice to indicate programming has failed.
12. Within 40 seconds, repeat button procedure to program additional remote transmitters
13. To exit programming mode, open driver’s door.
NOTE: A maximum of 4 remote transmitters may be programmed. If all four positions have previously been taken, you will need to use step 7b instead of 7a to add another remote.
Note: Toyotas can be ‘tricky’ to program. The programming procedure is not too complicated, but the system seems to be somewhat “fussy”. This is an exact procedure and must be followed precisely. Careful attention to the timing of the intervals usually solves most programming problems. Most Toyota customers report having to make several attempts before programming is successful. Note that the system will time out after 40 seconds of inactivity.
HINT: If programming “fails”, as indicated by 2 cycles of the door locks at step 12, continue repeating button procedure of steps 10 and 11 until the doors lock ONE time.
