Additional Information

Site Information

 Loading... Please wait...

2007-2010

Use this Procedure for Vehicles with Driver Information Center Buttons

NOTE: This information is in your Owner’s Manual in the Drivers Information Center Section.

1. Insert Key and turn to ON position so you can access Driver Information Center

2. Press the vehicle information button until   PRESS TO RELEARN REMOTE KEY displays

3. Press the set/reset button until   REMOTE KEY LEARNING ACTIVE displays

4.  Press and hold the lock and unlock buttons on the keyless remote at the same time until chime will sound indicating that the remote is programmed.

5.  To program additional remotes at this time repeat step 4.   

6.  To exit programming mode turn key off and remove key.

 

Use below Procedure for Vehicles without Drivers Information Center Buttons:

To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine)

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.

2. Press and hold the trip odometer reset stem for three seconds.  The message REMOTE KEY LEARNING ACTIVE will display

3.  Press and hold the lock and unlock buttons on the first keyless remote at the same time until a chime will sound indicating that the remote is programmed.

4.  To program additional remotes at this time repeat step 3.

5.  To exit programming mode turn key off and remove key.

    There are no products in this category.