1999 Passport
- Open the driver’s door.
- Insert key into ignition.
- Turn the ignition switch to the ACC position and then to the LOCK
position three times. (This step must be completed within 3
seconds – go as fast as you can, or the system will not enter the
programming mode.)
- Within 10 seconds, close and open the door two times.
- Turn the ignition switch to the ACC position and then to the LOCK
position ***three times (again, do this within 3 seconds.)
- Within 10 seconds, close and open the door. Verify that the power
door locks cycle once to confirm that the system is in
programming mode.
- Within 20 seconds, press the LOCK button on the transmitter you
are programming. Verify that the door locks cycle once.
- Within 20 seconds, press the UNLOCK button on the transmitter.
Verify that the door locks cycle once to confirm that the system has
accepted the transmitter’s code.
- Repeat steps 7 and 8 for each transmitter to be added.
- Remove key from ignition.
*** Some Passports require you to turn ignition on and off 5 times in step 5
