null

RS3000 VIP PROGRAMMING PROCEDURE

 

 

To program (add) a remote control to the system:

  1. Insert the key into the ignition switch and turn it to the on position. 
  2. Press and hold the ECU’s programming switch for 3 seconds.
    1. The status monitor LED turns on for 5 seconds.

NOTE: You must perform the next step within 5 seconds.

  1. Press and release remote top or bottom button.
    1. The status monitor LED turns off.
    2. The Piezo “chirper” chirps once.
    3. The exterior lights flash once.
    4. Turn off the ignition. The ECU will now operate with the remote control just programmed. 

 

To erase all remote control codes from the system:

  1. Insert key into the ignition switch and turn it to the ON position.
  2. Press and hold the ECU’s programming switch for 3 seconds.
    1. The status monitor LED turns on for 5 seconds.

NOTE: You must perform the next step within 5 seconds.

  1. Press and hold the ECU’s programming switch for over 2 seconds again.
    1. The status monitor LED turns off then flashes 3 times.
    2. The Piezo “chirper” chirps three times and the exterior lights flash 3 times.
    3. Turn the ignition to the OFF position. The ECU has cleared all remote control codes; until another remote control is programmed, the system will not work with any remote control.

NOTE: The ECU will be located in one of three places: underneath driver’s seat, under steering column, or under center console. (See pg. 2 for illustration).

--