null

1.  Locate the programming connector located in the LH trunk. Trim may
     have to be pulled back to access programming connector. ( Connector
     has black/white wires leading up to it and it is not connected to anything.)

2.  Jump programming connector terminals. Leave terminals jumped
     unitl step 6.

3.  System should now lock and unlock doors to indicate 
      programming mode has been entered. 

4.  Press any button on keyless remote once.
     System should now lock and unlock doors, indicating successful 
     programming of keyless remote.  

5.  Repeat step 4 for additional remote or other existing keyless remote.
    
     NOTE: A maximum of only two Keyless Remotes can be programmed.

6.  Remove programming connector jumper wire to exit programming mode.

7.  Test remote(s).

--